How to make a daytime running light with your own hands?

Table of contents:

How to make a daytime running light with your own hands?
How to make a daytime running light with your own hands?
Anonim
DIY daytime running light
DIY daytime running light

Currently, every car owner strives to make his "iron horse" as comfortable as possible. However, at the same time, do not forget about safety. Daytime running lights (DRLs) will help make your car more visible on the roadway, which, in turn, contributes to a significant reduction in the likelihood of accidents. Therefore, the installation of such equipment becomes not only a pleasant, but also a necessary addition to the appearance of your vehicle.

What will it take?

DIY LED running lights
DIY LED running lights

If you have firmly decided that installing running lights with your own hands is the only way out for your car, then you should immediately take care of the availability of all the required parts and tools. So, regardless of the model of your machine and the amount of work, you may need: a set of tools (wrenches, screwdrivers,pliers, etc.), electrical tape, adhesive (you can take both ordinary superglue and bottled compounds with sealing properties), a soldering iron, a bunch of wires, lamps and a control device. At present, LEDs are widely used. You can get them at any auto parts store. In addition, do-it-yourself LED running lights look quite impressive, and the costs are minimal. In addition, they have high technical characteristics, which allows them to be widely used.

Do-it-yourself installation of running lights
Do-it-yourself installation of running lights

Theoretical information

First you need to determine the place where the DRL system will be installed. It should be remembered that making a daytime running light with your own hands is quite simple, it is only important to take into account a few rules and requirements. For example, height restrictions (at least 250 mm from the ground) and width (maximum 400 mm from the side edge of the vehicle) must be respected.

Installation order

Once you have chosen the exact installation site, you can proceed to the practical part. First of all, all the parts involved in this process will be required. This event directly depends on what and how is arranged under the hood of your car. Therefore, you can install a daytime running light with your own hands only with a fairly good knowledge of your car. After that, all the necessary measurements are made, on the basis of which the marking of the locations of the DRL will be carried out in the future. At this stage, it is very important to keepsymmetry of the structure. After such preparations, you can mount a daytime running light with your own hands. A set of LEDs is attached to the selected points, then all the necessary wires are connected. Traditionally, such a system is tied to the ignition key so that the DRLs start working when the engine starts and turn off when the parking lights are turned on. Thus, a daytime running light (with your own hands, for example, installed) is responsible for your safety even when you do not know about it.

Recommended: