The battery is dead: how to light a car?

2024 Author: Erin Ralphs | [email protected]. Last modified: 2024-02-19 11:42

The winter cold period is always a kind of test for motorists and their iron horses. A common problem that many people have to deal with is a dead battery. Although it can fail not only in winter. Lights left on at night in the cabin, headlights not extinguished, an alarm screaming for a long time - all this can cause the battery to drain, and, consequently, a bad mood.

For people who are alien to the problems of a car, the question of how to light a car is perplexing. But motorists know how unpleasant the situation is when the energy of the car is over, and there is no spare battery. What to do in such a situation?

First, you should check if the battery is really to blame for the fact that the car will not start. After all, other reasons are possible. If, when the ignition is turned on, the headlights light up and the radio works, then you need to look for the cause in something else. And if, when you turn the key, there is no action from the side of the car, you will have to think about how to recharge the battery.

You can use the services of special field services that will arrive andrecharge your battery, but it is not always convenient in time, and you can be away from settlements. Therefore, apart from how to light a car from another car, there are no options left.

To get started, you will need special starter wires of the appropriate length with metal clips at the ends, as it will simply be impossible to light a car without them.

Next, you need to find a car enthusiast who is ready to help and provide his car for lighting. The "donor" car must be serviceable and full of energy, preferably with the same engine size as your car. If the "donor" is found, it's time to figure out how to properly light the car.

Cars are placed as close as possible, but without contact, and put on the parking brake. All devices that consume energy (headlights, radio, stove, air conditioner) must be turned off. The batteries of both vehicles must be sealed.

The start wires have (+) red and (-) black clips. Using protective gloves, you must first connect the pluses of both batteries with red clamps. Moreover, the first one necessarily clings to the discharged one, and the second one - to the "donor" battery.

With black clamps, the wire is first connected to the minus of the source, and then to the minus of the discharged battery, and, better, to the metal of the engine or starter, the so-called mass.

Before you light a car, you mustcarefully check the correct connection of the starting wires. Now you need to start an assistant for a few minutes, and then check the condition of the rechargeable car. If it starts, do not immediately remove the wires, let both motors run a little.

The wires are removed in the reverse order, first the black clip from the mass of the charged car and from the minus of the "donor" battery, then the red from the plus of the "donor" and from the plus of the charged battery.

That's the whole answer to the question of how to light a car. It should be noted that this is not difficult, but quite dangerous, so you must follow safety precautions and battery operation rules.