Highlighting the bottom with your own hands

Highlighting the bottom with your own hands
Highlighting the bottom with your own hands
Anonim

Today, during the rapid development of science, there are such mechanisms that we could only dream of before. In this regard, tuning cars every year is only gaining momentum. At various exhibitions and competitions, unique models appear, often existing in a single copy. One of the most important elements in such a car is lighting tuning, where the illumination of the underbody of the car is a key element.

do-it-yourself bottom lighting
do-it-yourself bottom lighting

If earlier it was necessary to solder the circuits, install protection and carefully isolate all the backlight elements, today there are ready-made systems on sale. Such devices simply need to be fixed in the desired place and connected to the battery. If you decide to save money or make your own unique system, then do-it-yourself bottom lighting will be an ideal option for you.

Before starting work, be sure to wash the car well, as dirt and sand will prevent you from doing a good job. Illumination of the bottom with your own hands - the processquite simple, but requires some skills and abilities. Work should begin with marking and studying the most suitable places for installing all the elements. It should be remembered that competent lighting begins with the quality of the selected parts, in our case it will be an LED strip. Tapes differ not only in brightness (the brighter the light, the smaller the distance between the diodes), but also in protection from external factors. Moisture is the main threat. Therefore, all elements are divided into moisture resistant and ordinary.

car underbody lighting
car underbody lighting

As mentioned earlier, do-it-yourself bottom illumination begins with marking and calculating the length of the tape. To glue the entire car around the perimeter, you need about 5 meters of tape, where 3.6 meters goes to the thresholds, and 2.4 meters to the bumper. If you decide to install a backlight on the wheels, then 50 centimeters for each disc will be enough for you.

Perhaps the most important step in this work is soldering and sealing, as severe weather conditions in our country can lead to the formation of microcracks and the ingress of harmful reagents. As a result, the contact may begin to fail or even break due to frequent vibrations. Do-it-yourself bottom illumination always occurs with the help of hot-melt adhesive and a transparent heat-shrink tube. Some prefer to use auto sealant instead of glue.

The LEDs are mounted through jumpers made of perforated mounting tape with a step of 7-10 centimeters both on the bumpers and on the thresholds. It should be remembered that it is necessary to retreat asat least 15 cm from the edge of the bumper (or threshold) so that the diodes are not visible.

neon underbody lighting
neon underbody lighting

It is recommended to connect clockwise, starting from the driver's threshold. Illumination of the bottom, made according to such a scheme with your own hands, allows you to combine all the elements together. After the installation is completed, it is necessary to check the operability of the LEDs by connecting electricity to them for a while. If everything is working properly, then it's time to wrap the central wire in a corrugation and pull the shortest path to the battery. We connect the positive wire through a 10 ampere fuse to the battery, we lead the negative wire into the cabin through the seals. We install a switch on it and connect the wire to the ground of the body.

Neon bottom lighting is not as complicated as it might seem at first glance, but if in doubt, it is better to abandon the idea of doing everything yourself. Now many service stations are ready to carry out the necessary work at an affordable price.

Recommended: