Do-it-yourself cabin filter replacement

Table of contents:

Do-it-yourself cabin filter replacement
Do-it-yourself cabin filter replacement
Anonim

Replacing the cabin filter is a simple operation that will take no more than five minutes (to dismantle the old filter and install a new one). However, in specialized salons they charge a lot of money for this, which is absolutely unjustified.

You can buy a filter at any auto shop or service center. You need to pay attention to the quality of the product. It is recommended to buy parts from authorized dealers, thus, the components will last longer, and the need for frequent repairs is completely eliminated.

Let's consider how the cabin filter is replaced in Toyota Corolla and Mazda 3.

Cabin filter replacement
Cabin filter replacement

About Toyota

In almost all cars, the cabin filter is located under the glove box. Toyota engineers decided not to swim against the current, and placed it there.

So, the process itself! Initially, pull out the glove box and unscrew the fixing fastener on the right side of the structure. Next, the entire glove compartment is dismantled, for this the side walls are squeezed a little and it is pulled out.

Cabin filter replacementToyota Corolla
Cabin filter replacementToyota Corolla

Replacing the Toyota Corolla cabin filter is carried out by removing the plastic cover, which is attached to the niche. The lid latches come unfastened and the filter is removed. The new one is inserted so that its edges are slightly pressed. After the structure is in place, it snaps into place.

Now it remains only to install the glove box. Its walls, as it was during dismantling, are compressed so that the pins enter the grooves, after which the nut is tightened.

About Mazda

Replacing the Mazda 3 cabin filter is also quite simple. First of all, you need to disconnect the battery, as the work will be carried out near current-carrying circuits.

In the glove compartment of the car, the socket is snapped off with the help of tools and dismantled by moving to the left. There are fasteners under it, they should be unscrewed, and the glove box body will slide out. Under the glove compartment is a plastic protection, it is fixed on two fasteners. After its dismantling, another clip is dismantled to the left of the passenger seat, this time the protective panel is removed and access to the fuse box mounts is provided.

Next, the replacement of the cabin filter is carried out by dismantling the fuse box, its connector is disconnected, and finally, you can remove the filters. Mazda 6 has two filters. Before installing new ones, it is necessary to wipe the compartment well, remove the accumulated debris and assemble everything in the reverse order.

Replacing the Cabin Filter Mazda 3
Replacing the Cabin Filter Mazda 3

After the work is completed, you need to put on the battery terminals and checkperformance of all devices. When power is restored, it is recommended to set the initial position of the power windows. To do this, the motor is started, and each glass is fully raised using a button. To do this, hold it for at least 3 seconds (after complete closure). When characteristic clicks are heard, release the button and perform the operation for the lower position of the glass.

If the cabin filter is replaced by yourself, it is recommended to glue it with an additional foam seal, which is used to insulate household windows. This allows you to conveniently mount the product, eliminating the gaps between the part and the body.

Don't waste your money when it's so easy to do it yourself!

Recommended: