MAZ-551605: equipment options

Table of contents:

MAZ-551605: equipment options
MAZ-551605: equipment options
Anonim

The family of new three-axle dump trucks under the designation MAZ-5516 has been produced at the Minsk Automobile Plant (MAZ) since 1994. Distinctive features of the family are the simplicity of design and a large margin of safety. These factors are considered decisive when buying new or used cars based on the MAZ-5516. Buyers are not afraid of either the low corrosion resistance of the cabins or the unstable quality of the plant's products.

Development

The first prototype of the modernized car under the designation MAZ-551605 was created in April 2002. The YaMZ-238DE2 diesel engine was used as a power unit. In the future, the base chassis was used to install various superstructures - dump bodies of various configurations, concrete mixers, utility vehicles, etc. Thanks to the powerful main engine, it was possible to ensure the high technical characteristics of the MAZ-551605.

maz 551605
maz 551605

The chassis has a drive to two rear axles, which provides good cross-country ability and allows the use of machines in difficult road conditions. To meet modern requirements, an anti-lock braking system is used in the brake system.system. On request, the chassis is equipped with a comfortable cab with additional insulation and seat belts for all seats, an autonomous engine heater, and a speed limiting system.

Tipper

A three-axle dump truck based on the MAZ-551605 is designed to transport bulk cargo with different fraction sizes. Its body can be unloaded in three directions. There are several variants of the dump truck, differing in the type of cab, type of dump body and the ability to work in conjunction with a trailer.

Currently produced cars can be equipped with YaMZ-238DE2 diesel engines or a more powerful YaMZ-7511-10E2 engine. Both engines comply with Euro 3 emission standards. Motors are equipped with gearboxes either domestically produced (model YaMZ-2381) or imported. The nominal load capacity of all dump trucks is 20 tons.

One of the activities of the car is the transportation of agricultural goods. MAZ-551605-271 with high sides of the body is designed to perform such work. If necessary, the dump truck can carry any bulk cargo. The one-way dump body has an exhaust floor heating system. The machine is equipped with a sprung cab without a sleeper.

MAZ 551605 characteristics
MAZ 551605 characteristics

The power unit consists of a 330-horsepower diesel engine with a YaMZ-238DE turbine and a nine-speed gearbox model 9JS135A. The machine has a long range thanks to the 350L tank.

Concrete mixer

Designed and produced on the "Mazov" chassismixer for cement and concrete mixtures under the designation ABS-8 YES. The concrete mixer is designed for a wide temperature range of operation (from minus 30 degrees to plus 40).

The working drum with a capacity of 8 cubic meters is made of steel sheet and has an adjustable tray for discharging the mixture. The drum is loaded from above, through a special neck. The height of unloading is regulated by the slope of the tray and additional chutes and can reach 2 m from the ground level. The average unloading speed is about one cubic meter per minute.

MAZ 551605 specifications
MAZ 551605 specifications

For mixing the mixture on the go, a separate 50-horsepower diesel D-144 with air cooling is used. Rotation is transmitted to the drum through a gear reducer. The maximum drum rotation speed is up to 14 revolutions per minute. The concrete mixer ABS-8 YES on the MAZ-551605 chassis has good speed characteristics - the maximum speed of a loaded machine reaches 50 km/h, and empty - up to 75 km/h.

Recommended: